Morel MPS 1.550 Amp Monoblock Class D Mono Subwoofer Amplifier 550w RMS at 2ohms

Morel MPS 1.550

Mono subwoofer amplifier — 550 watts RMS at 2 ohms

Sub power

Morel built this MPS 1.550 amplifier so their subwoofers would have an amp worthy enough to power them, delivering high-fidelity musical reproduction along with pure, clean power. The MPS 1.550 can send up to 550 watts RMS to your subwoofer, boosting bass clarity and emotional impact.

Low-noise design

Morel made sure that every detail of this amplifier's design would result in lower noise and higher sound quality. The amp's Class D architecture puts out clean signal with very little noise, while balanced differential inputs reject interference. An onboard microprocessor controls the thermal management system, keeping the amp running cool and steady no matter how hard it's driven. All the connections are on one side of the amp to keep wiring neat, organized, and simple for the installer.

Tone controls for every occasion

The low-pass and subsonic filters, bass boost, and gain controls sit protected under a top panel. Their intuitive operations and functions make it easy to match the amp's output to your sub — and achieve great sound. This amplifier's modest exterior shelters high-quality electronic components that guarantee an accurate and musical performance..

• mono subwoofer amplifier
• 350 watts RMS x 1 at 4 ohms (550 watts RMS x 1 at 2 ohms)
• Class D amp technology
• 100 dB signal-to-noise ratio, 0.15% distortion
• variable low-pass filter (40-220 Hz, 12 dB/octave)
• variable bass boost (0-12 dB at 45 Hz)
• switchable subsonic filter (off, 25, 35 Hz)
• optional MPS-R1 wired remote level control available soon
• preamp and speaker-level inputs
• speaker-level inputs require speaker wire to RCA adapters
• speaker-level inputs feature DC offset or signal sensing turn-on
• wiring, fuse, and hardware not included with amplifier
• 8-gauge power and ground wires and a 50-amp fuse recommended
• 9-3/8"W (including flange) x 2-1/8"H x 6-3/4"D