Cobble Grip

Cobble Grip is a water based semi-gloss finish sealer that helps protect travertine, natural stone and dense concrete pavers.   Gallon Size call for larger sizes

Cobble Grip will provide resistance to UV, mildew and staining. Cobble Grip dries clear and cleans up with water. Cobble Grip can be used on driveways, patios, walkways, and pool decks. Apply to surfaces that are unsealed, clean, sound and penetrable.

Product Features 

• Eco friendly & emits low VOC’s
• Easy to apply
• Inhibits algae, weeds and ant hills

Applications

• Use Cobble Grip on driveways, patios, pool decks, parking lots, walkways, etc.
• Cobble Grip is not recommended for pavers installed over a solid surface or on surfaces where moisture is unable to dissipate.

Directions

Always mix thoroughly before use. Continue to mix throughout application. Cobble Grip is ready to use.

Apply one or two coats at 300-500 square feet per gallon per coat, depending on porosity. Apply using a medium 3/8” nap roller. Spray application requires a low-pressure pump sprayer or an airless paint sprayer using minimum 517 tip. Do not allow product to puddle or pond.

Ambient temperatures should be at least 50 °F and below 100 °F.  Thinning of this product is NOT recommended. 

Back roll puddles/runs as they occur. Do not pour product onto horizontal surfaces to spread.  After application dries, water should bead or sheet off the surface, if not, an additional coat may be required. Allow coating to dry (enough to be walked on) 2-6 hours between coats.

Second coat should be rolled/sprayed in the opposite direction of the first coat so that the overlaps do not align. A full cure takes approximately 48 hours.

Heavy traffic on coated surface should be avoided during this curing period.

ON PAVERS - Backroll any sealer that is puddled on the pavers. A second coat of sealer may be desired; depending upon the porosity of the brick.

MAY BE USED AS A TOPCOAT OVER COLORCRETE OR TD ONE STEP

Apply one uniform coat Undiluted, at 4 to 6 wet mils.  To avoid buildup of sealer, do not reapply Cobble Grip more than once every 18 months.