Lightweight Interfacing

[Product description] 

Fusible interfacing is adhered to fabric with an iron.
When making clothes, bags, or small items, applying interfacing to fabric prevents deformation and makes wrinkles less likely even after repeated washing.

Lightweight Interfacing

Thin but with moderate stiffness, giving shirts’ collars and front plackets a crisp finish.
Usage: collars, front plackets, facings of shirts and blouses
Suitable materials: muslin, lawn, broadcloth, sharting fabric, etc.
Recommended iron temperature for fusing: 120–140℃

*Please refer to the “Fusible Interfacing Comparison Chart” image for stiffness and thickness of interfacing.
*In the second image, the gray board is placed on the right half.

[How to Use]

• The side with a shiny (reflective) or rough surface caused by adhesive resin is the adhesive side. Place this side down onto the back side of the fabric.

• Set the iron to dry mode and press without sliding, holding about 10–15 seconds per spot.

[Notes]

• Iron temperature varies by interfacing; please refer to the recommended temperature in the product description.

• Use dry iron only; do not use steam.

• Usage, suitable materials, iron temperature, and pressing time are guidelines. Please test with scraps before use.

• When applied to sheer materials, adhesive resin may seep through or reduce transparency, so be cautious.

[Material]
65% Polyester
35% Cotton
Made in Japan

[Fabric Width]
Approx. 85 cm